Dell Chromebook 3110 2-in-1 Service Manual page 27

Steps
1. Place the palm-rest assembly on a flat surface.
2. Align the display assembly with the screw holders on the palm-rest assembly.
3. Replace the six screws (M2.5x5) to secure the display assembly to the palm-rest assembly.
4. Adhere the display cable on the system board.
5. Connect the display cable to the connector on system board.
6. Align and place the display-cable bracket on the display-cable connector on the system board.
7. Replace the screw (M2x4) to secure the display-cable bracket to the display-cable connector on the system board.
8. Route and adhere the WLAN antenna cables and G-sensor cable through the routing guides on the palm-rest assembly.
9. Connect the G-sensor cable to the connector on the system board.
For Chromebook 3110 2-in-1, the G-sensor cable needs to be taped down to the palm-rest and routed underneath the WLAN
antennas.
10. Connect the WLAN antenna cables to the connectors on the WLAN card module.
NOTE: For systems shipped with WLAN capabilities, route both WLAN antenna cables underneath the tab on the right
display hinge, then into the rubber cable holder.
11. Replace the WLAN card bracket on the WLAN card module to secure the two antenna cables.
12. Replace the single screw (M2x3) to secure the WLAN card bracket to the WLAN card module on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing components 27