Table of Contents
Advertisement
INSTALLATION
B
C
1.
Be sure heater is unplugged before attempting to install the components.
2.
Place the heater in an 'upside down' position with the back of the heater facing you.
3.
Remove the two of the pre-installed case screws (B) from the base of the appliance (C).
4.
With the front end of the foot (A) pointed towards the front of the heater, align the two holes in the foot with
the two holes in the base the appliance and fix in place with the screws (B) removed in step 3. Make sure the
direction of the feet is facing the right way when attaching.
5.
Repeat steps 3 and 4 to install the second foot.
6.
Rotate the heater back to the upright position and remove the cable tie from the flexible cord, then insert the
power plug of the heater directly into a power socket outlet.
DO NOT bundle or coil the flexible cord to reduce the length as overheating and subsequent fire
hazard could result.
IMPORTANT
7.
The heater is now ready to be used as a free standing appliance. Refer to the operation section at the front
of this manual for full instructions on how to use the heater.
Rinnai
B
B
A
18
B
A
Back of heater
Electric Panel Heater OIM
Advertisement
Table of Contents
