Table of Contents
Advertisement
Quick Links
THIS MANUAL MUST BE READ IN ITS
ENTIRETY BEFORE OPERATING HEATER
Owners Operation and Installation Manual
WARNING: If the information in these instructions are not
followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
This heater has been designed to code ANSI Z 21.88a-2000
effective 7-1-2002
This appliance is only for use with the type of gas indicated on
the rating plate.
This appliance is not convertible for use with other gases.
INSTALLER: MUST LEAVE THIS MANUAL WITH THE UNIT AFTER INSTALLATION
OWNER: RETAIN THIS MANUAL SAFELY, FOR FUTURE REFERENCE
HOME OWNER / INSTALLER
FOR YOUR SAFETY
FS35BN/US
FS35BL/US
Gas Radiant Space Heater
WHAT TO DO IF YOU SMELL GAS
Advertisement
Table of Contents
Related Manuals for Rinnai FS35BN/US
Summary of Contents for Rinnai FS35BN/US
- Page 1 HOME OWNER / INSTALLER FOR YOUR SAFETY THIS MANUAL MUST BE READ IN ITS ENTIRETY BEFORE OPERATING HEATER FS35BN/US FS35BL/US Gas Radiant Space Heater Owners Operation and Installation Manual WARNING: If the information in these instructions are not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
-
Page 2: Limited Warranty
Authorized Rinnai Distributor. Rinnai will not pay labor charges associated with the repair or replacement of the product or any part or component. All repair parts must be genuine Rinnai parts. All repairs or replacements must be performed by an individual or servicing company that has been authorized by Rinnai or its distributor. -
Page 3: Table Of Contents
MAINTENANCE CAN CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER. This manual applies to the following models only: FS35BN/US FS35BL/US Freestanding Fire Table of Contents Limited warranty ......................2 Contacts ........................ -
Page 4: Specifications
SPECIFICATIONS Model: FS35BN/US (NG) United States FS35BL/US (Propane) United States Description: Freestanding radiant/convector, glass-fronted, ceramic log space heater with forced convection and natural draft flue system Output: 26,000 Btu/hr Natural Gas 23,000 Btu/hr Propane Gas Control: Push button combination control valve... -
Page 5: Important Points / Usage And Installation Musts
IMPORTANT POINTS / USAGE AND INSTALLATION MUSTS Unpack the heater and check for damage (DO NOT INSTALL DAMAGED HEATER). If the heater is damaged, contact your supplier for advice. Before installing the heater, check the label for the correct gas type (see rating plate, bottom right hand side of pillar). Refer to local gas authority for confirmation of the gas type if you are in doubt. - Page 6 The appliance must be isolated from the 15 LPG containers must not be installed gas supply piping system by closing its indoors. equipment shutoff valve during any pressure testing of the gas supply piping 16 Do not use this appliance if any part has been under water.
-
Page 7: Technical Specifications
LEAST ANNUALLY 37 Caution: Do not operate unit with broken PROFESSIONAL SERVICE PERSON. glass. MORE FREQUENT CLEANING MAY 38 WARNING: DO NOT OPERATE BE REQUIRED DUE TO EXCESSIVE APPLIANCE WITH THE FRONT LINT FROM CARPETING BEDDING REMOVED, CRACKED OR BROKEN. MATERIAL, ET CETERA. -
Page 8: For Your Safety Read Before Operating Heater
FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A This appliance is equipped with an a neighbor’s phone. Follow the gas ignition device which automatically suppliers instructions. -
Page 9: Operation
OPERATION For your convenience the controls on your new Flame Fire are situated under the cover on the top right-hand side of the fire. All necessary adjustments to the operation of your fire can be made with these controls. • TO TURN ON THE PILOT “OFF”... -
Page 10: Location
LOCATION When positioning the heater, the main points governing the location are: 1. Flue connection and proper venting 5. The heater is not designed to be built into bookcases or shelves or any 2. Warm air distribution. combustible opening. 3. Adequate air supply. 6. -
Page 11: Venting
VENTING Use only an approved B Vent system horizontal at any stage. There must not be more than 2 bends in any system. • Position the heater. Any horizontal section of flue must be less than 1/3 the length of vertical flue •... -
Page 12: Log Installation
LOG INSTALLATION The logset is packed inside the unit and the packaging must be removed prior to installing the logset in its correct position. • Open both side panels. • Remove fasteners on both sides of the top glass retainer. •... -
Page 13: Testing And Commissioning
TESTING AND COMMISSIONING • TESTING PROCEDURE Turn gas supply on and plug the unit into It is the responsibility of the installer to the power supply. (Caution 115V) check that under normal operating conditions of the appliance, all flue gases are exhausted to the outside atmosphere and that there is no spillage of combustion •... -
Page 14: Maintenance Instructions
MAINTENANCE INSTRUCTIONS IMPORTANT MAINTENANCE INSTRUCTIONS • ANNUAL INSPECTION A heater should not be used if you suspect there may be a problem, and a service The unit should be inspected at least once agent must be called to investigate the a year by a qualified service technician cause of the problem. - Page 15 The heater should be serviced annually only by an authorised person. • GLASS REPLACEMENT CLEANING. (May be performed by the owner) It is best to handle the glass with clean gloves to avoid smearing the glass with finger prints which might show after replacement.
-
Page 16: Wiring Diagram
WIRING DIAGRAMS Wiring Diagram Wiring Diagram Ladder Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. TROUBLE SHOOTING SYMPTOM CAUSE SOLUTION Burner will not light No power present Ensure power cord is plugged in and turned on No gas present... -
Page 17: Exploded Diagrams
EXPLODED DIAGRAMS... -
Page 19: Parts List
PARTS LIST ITEM NO. QTY. PART NO. DESCRIPTION 7992-1 FLUE SPIGOT ASSY FS NAT USA 7074 HEAT EXCHANGER FRONT ASSY 3+3H 7075 HEAT EXCHANGER REAR ASSY 3H 6624 BURNER EXCHANGER TRANSFER TUBE 6625 BURNER HEAT EXCHANGER BRACKET 7028-5 FLUE SPIGOT DRAUGHT DIVERTER 7996 COMB CHAMB ASSY FS 3H US PAINT 7066... - Page 20 6635 FAN SWITCH R210 6642 O RING REH210 7280 SWITCH MTG BRACKET FS 7046 CONTROL ROD BENT 5476 SNAP PIN R22SL/FL FIRES 57AG3 7045 CONTROL ROD BRKT 6643 MAIN GAS TUBE RETAINER (3) 7065 AIRGUIDE LOWER FS MANUAL PAINT 7071 HEATSHIELD LOWER RH FS MAN 7060 HEATSHIELD LOWER LH FS...
-
Page 21: Installation Notes
INSTALLATION NOTES... - Page 22 INSTALLATION NOTES...
-
Page 23: Installation / Commissioning Checklist
INSTALLATION / COMMISSIONING CHECKLIST 1. Was a fireplace inspection carried out? (i.e. clearances, combustibles etc.) 2. Was a manufactured flue system installed? 3. Has specified gas pressure been set? 4. Are decorative logs located correctly on pins? 5. Have ember granules been placed and free of dust and powder? 6. - Page 24 Part Number 7916...