Table of Contents
Advertisement
ABOUT YOUR ELECTRIC PANEL HEATER
WARNING KEEP BATTERIES OUT OF REACH OF CHILDREN.
Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns
and potential perforation of the oesophagus.
If you suspect your child has swallowed or inserted a button battery immediately call the
24-hour Poisons Information Centre on 13 11 26 for fast, expert advice.
Examine devices and make sure the battery compartment is correctly secured, e.g.
that the screws or other mechanical fasteners are tight. DO NOT use if compartment is not secure.
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous and may be a choking hazard.
Inform others about the risk associated with button batteries and how to keep their children safe.
Remove the batteries if the remote is not going to be use for prolonged periods. This will help prevent damage from leaking
batteries. If leakage has occurred and corrosion is evident the remote will need to be replaced.
Leaking chemicals are toxic and MUST NOT be touched or ingested.
NEVER mix old and new batteries.
DO NOT immerse the remote control in any liquid, this will damage the remote control, rendering it inoperable and voiding
its warranty.
FIT BATTERIES
1.
To open the secure button battery compartment, push and hold the little release button, then slide down to
open the cover according to the direction indicated by the arrow head.
The remote is designed with a secure, child-resistant battery
compartment which prevents children access to the button
NOTE
batteries.
2.
Install the button battery (CR2025/3V). Make sure the positive pole
faces up.
3.
Put back the cover securely into place.
Remember to dispose of used button batteries immediately
and safely.
IMPORTANT
IMPORTANT STEPS
1.
Aim the remote control towards the receiver on the front of panel heater.
2.
The remote control should be within 5 metres away from the receiver.
3.
Ensure there are no obstacles between the remote control and the receiver.
4.
Do not drop or throw the remote control.
5.
Do not leave the remote control in the sun or near heating devices.
6.
Only use the button battery (CR2025/3V). Ensure the battery cover is securely in place.
The diagram shown of the Remote Controller is an example only. The image contains almost all
of the function buttons. Remote Controllers may be slightly different from illustrated diagram
NOTE
depending on which model purchased.
Rinnai
14
CR2025
OPEN
PUSH
RELEASE
Electric Panel Heater OIM
Advertisement
Table of Contents
