Part Names And Functions - Panasonic GA-ML24TPoE+ Installation Manual

2

Part Names and Functions

Power port
Back panel
MAC Address label
ECO MODE
ON･･･BLINK
OFF･･･LIGHT
GA-ML24TPoE+
Front panel
POWER STATUS/ECO
LED DISPLAY
CHANGE BUTTON
PoE LIM.
KEEP PRESSING 3SEC
ECO MODE ON/OFF TEMP
FAN
Serial Number label
 Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
 Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
 Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
 10/100/1000BASE-T ports (ports 1-28)
Ports 1 to 24 can supply PoE power confirming with IEEE802.3at/af.
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Ethernet
Switch can be connected to this port. Install the device so that the length of twisted pair
cable (CAT5e or above) becomes 100m or less.
 SFP extension slot (ports 25-28)
Install SFP module. (It becomes exclusive usage with twisted pair port.)
When SFP extension slot is linked, the ports are automatically switched to SFP
extension mode.
SFP port supports only the full duplex communication.
 Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage
this Ethernet Switch.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
Flow control
12
AC100-240V
Ground terminal
10/100/1000BASE-TX ports supporting PoE power supply
1 3 5
GIGA
FULL
LOOP
HISTORY
2 4 6
: 1 bit
: None
Power cord hook block
RIGHT LED（ORANGE）：LOOP DETECTION
7 9 11 13 15 17 19 21 23
8 10 12 14 16 18 20 22 24
10/100/1000BASE-TX ports
Emulation mode
Data length
Parity control
Transmission connector : RJ45
SFP extension slot
25 27 SFP▲（25） SFP▲（27）
CONSOLE
9600.N.8.1（DTE）
26 28
SFP▼（26） SFP▼（28）
Console port
: VT100
: 8 bits
: None