Table of Contents
Advertisement
Manual Override Function:
When powered on, the PIR sensor enters a "warm-up" period for about 20 seconds (the red LED sensor
indicator will light on), then automatically switches into AUTO MODE.
During AUTO MODE, by switching the mains switch OFF – ON – OFF – ON in about 2 seconds, the PIR sensor
will automatically change into MANUAL MODE, the lights will remain ON, and with NOT be controlled by time
duration or ambient light (LUX) levels, The MANUAL MODE will change to AUTO MODE in 6 hours
automatically.
During MANUAL MODE, by switching the main switch OFF then back ON again, the PIR sensor will reset the
"warm-up" period and then AUTO MODE.
SPECIFICATIONS
1. Detection Method: Passive Infrared Sensor (PIR)
2. Sensor Range: 2M - 15M x 220 degree spread (approx.)
3. Time Adjustment: 5 seconds to 7 minutes (approx.)
4. Power Source: 220-240VAC/50Hz
5. With AC COB LED Chip: 2 pcs * 18W
6. Load Rating: No extra Lights should be added to this unit
9
Advertisement
Table of Contents
