Installation; Step 1. Installing The Mounting Bracket - NightWatcher NW16TSP User Manual

Step 1. Installing the Mounting Bracket

Line up the holes of the light back cover plate D with the holes on your wall. Using

the two Drywall Screws C and fix it tightly in ide the wall using the Plastic Masonry Plug E.
WARNING: Risk of electric shock. Disconnect power at fuse or circuit breaker
before installing or servicing.
CAUTION: Do not cut any wires with factory installed wire connectors or
remove the wire connectors.
Step 2: Wiring the Light Fixture
Connect the light wires inside the connection block .The mains wire should pass through the

Plastic Cover Bracket (D)
 Neutral (Blue) to Neutral (Blue)
 Earth (Green) to Earth ( Green/Yellow}
 Live ( Brown) to Live (Brown )
Note: Make sure the polarity is correct.
5

INSTALLATION