Table of Contents
Advertisement
Foundation
Steel rack
5.3 BASE PLATE
RISKS
PERSONAL PROTECTIVE EQUIPMENT
Before proceeding, check that the necessary conduits are in place (§
4.3-5).
The base plate and corresponding hardware are accessories which are
not included.
1. Assemble the base plate as shown in 11; tighten the supplied
M10 nuts and locknuts, using two hex spanners.
2. Pour a slab, with reference to 6 and 7 in § 5.2 and 12.
3. Take the cable conduits out from the hole (12-1) and install
the base plate.
Do not bury the base plate in the concrete.
4. Use a spirit level to check that the slab is horizontal, making any
corrections before the concrete goes off (12).
5.4 FASTENING THE GEAR MOTOR
RISKS
PERSONAL PROTECTIVE EQUIPMENT
Wait for the concrete to cure fully before proceeding.
!
Lift the gear motor, holding it by the base.
1. Pass the cables through the two holes on the gear motor (13-1).
2. Position the gear motor, lining up the slots and the screws on the
plate (13-2).
3. Pass the cables through the supplied cable glands, then insert the
cable glands in the holes (13-3).
!
If one of the two holes will not have cables running through it, insert
the plastic cable gland whole.
BLIZZARD 500-900
14
0
1
2
3
4
5
6
2x17
1
12
10
1 1
1 2
532102 - Rev.B
Advertisement
Table of Contents
