Volvo A60H Manual page 26

29. Push part number #A16 onto the 6 motor shafts noting the flat side on the shaft needs to
align with one of the M3 bolt mentioned in above. Once pushed on, tighten the bolt
opposite the shaft flat first then tighten the bolt on the shaft flat side, this helps keep the
wheel square on the shaft.
30. Using M6x16mm bolt attached Bruder wheel over supplied re-enforced wheel. Repeat for all
6 wheels.
31. Feed motor wires through the cable holes in the chassis back to the front cab.
32. Install battery, ESC's, receiver and connect up to the motors and receiver.
33. Test operation.
Version 1 Page 26 28/09/20