Connecting To A Garmin Vhf Comm Radio - Garmin aera 190-01117-02 Pilot's Manual

Removing the yoke mount from the yoke shaft (or control arm):
1) Disconnect the cable connectors from the aircraft.
2) Loosen the clamp by turning the Clamp Adjustment Knob until the clamp
assembly can be easily removed from the yoke shaft or control arm.

cONNectiNG tO a GarMiN vhF cOMM radiO

The aera can also output frequency data to a Garmin aviation radio. Currently the
two models supported are the SL30 nav/comm and the SL40 comm.
NOte: For additional information refer to the SL30 nav/comm or the SL40
comm installation manual.
cautiON: This interface does not have an FAA installation airworthiness
approval. If any abnormalities with SL 30/40 tuning or operation are
encountered, disconnect the aera from the SL 30/40 tuning interface.
Output frequency data to an Sl40/Sl30 nav/comm radio:
1) Connect the aera to an SL30/SL40 using the Aviation Bare Wire Connector
(optional accessory).
190-01117-02 Rev. A
Cable Clamp
Garmin aera 500 Series Pilot's Guide
appendix d
139