Related Manuals for KEP RTP
Summary of Contents for KEP RTP
- Page 1 Pulse Input Ratemeter and Totalizer INSTALLATION & OPERATING INSTRUCTIONS KESSLER-ELLIS PRODUCTS 10IndustrialWayEast Eatontown, NJ 07724 800-631-2165 • 732-649-7100 Fax: 732-649-7099 http://www.kep.com 99716 02/19/07...
- Page 2 Proprietary Notice The information contained in this publication is derived in part from proprietary and patent data. This information has been prepared for the expressed purpose of assisting operating and maintenance personnel in the efficient use of the instrument described herein. Publication of this information does not convey any rights to use or reproduce it or to use for any purpose other than in connection with the installation, operation and maintenance of the equipment described herein.
-
Page 3: Table Of Contents
TABLE OF CONTENTS SAFETY INSTRUCTIONS ............1 DESCRIPTION & SPECIFICATIONS .......... 2 MOUNTING.................. 3 WIRING ..................3 PROGRAMMING MENU.............. 5 PROGRAMMING FLOWCHART..........7 ANALOG OUTPUT CALIBRATION..........13 SOLDER JUMPERS ..............13 WARRANTY................. 14 DECODING PART NUMBER............14... -
Page 5: Safety Instructions
SAFETY INSTRUCTIONS The following instructions must be observed. • This instrument was designed and is checked in accordance with regulations in force EN 60950 (“Safety of information technology equipment, including electrical business equipment”). A hazardous situation may occur if this instrument is not used for its intended purpose or is used incorrectly. -
Page 6: Description & Specifications
PULSE INPUTS If activated by rate, the relay pulls in at High Preset or above The RTP can accept two pulse inputs ( A&B ). It computes and remains on until rate falls below Low Preset. rate and total of A, B, A+B and A-B. For both inputs the LOCKOUT The unit program and presets can be protected user can define up to 16 points of “k”... -
Page 7: Mounting
MOUNTING HOW TO MOUNT: Slide the body of the unit through the rubber gasket. Insert than .1” may distort if the clamps are screwed too tightly. the unit into the panel. Slide the brackets up the groove to Do not over tighten! A normal level of torque is required. press against the back of the panel. - Page 8 WIRING (CONTINUED) TERMINAL DESIGNATIONS: TYPICAL WIRING HOOKUPS: AC Power DC Power 1 • + DC INPUT (24VDC ± 10%) 1 • AC1 100 TO 260 VAC INPUT A INPUT A 2 • – DC INPUT (24VDC ± 10%) 2 • AC2 100 TO 260 VAC 3 •...
-
Page 9: Programming Menu
The unit is capable of showing nine different parameters. The parameters are the readings RTP gives after a pulse input is RTP gives after a pulse input is Each counter can be reset to zero or disabled. The Grand Total given to it. - Page 10 PROGRAMMING MENU (CONTINUED) Setup Security: Setup Comm port : Unauthorized front panel changes can be prevented by entering In this menu, the unit can be assigned a unique ID and the com- a user selectable four digit code. The unit can be in LOCK ALL munication parameters, i.e.
-
Page 17: Analog Output Calibration
ANALOG OUTPUT CALIBRATION Analog Output Calibration Procedure: The calibration of the RTP can be done in the following way : RTP can be done in the following way : Connect the following circuit to terminal pins 11 and 12, i.e Analog O/P (+) and Analog O/P (-). -
Page 18: Warranty
Example: Example: Example: Example: Series: RTP= Pulse Input Ratemeter KEP is dedicated to providing complete cus- Totalizer Operating Voltage: tomer service and customer satisfaction. If A= 110 VAC ± 15% you have any comments or criticisms about B= 220 VAC ± 15%...