Control Unit - Furuno SEARCHLIGHT CH-250 Installation Manual

1.1.4

Control unit

On blackbox type, fix the control unit to the mounting plate (supplied as accessories).
See the parts list of FP06-01120 and outline drawings at the back of this manual.
1. Fix the mounting plate to the place selected with two tapping screws (5x20, supplied).
2. Fix the bracket to the control unit with two hex. screws (M4x12, supplied).
3. Insert the screw driver from the top of the mounting plate holes and then tighten two hex.
screws (M4x12) loosely.
4. Attach the control unit to the mounting plate, and fasten two hex. screws tightly.
5. Attach two cosmetic caps to holes at the top of the mounting plate.
Cable entrance hole
Bracket
Cable can be passed this direction.
6. Attach hard cover to protect the control unit.
How to remove the hard cover
Place your thumbs at the locations shown with
circles in the illustration at right, and then lift the
cover while pressing it with your thumbs.
On mounting the control unit separate from the monitor unit, the optional control unit separate kit
is required. Mount the control unit same as the above procedure. See the outline drawing at the
back of this manual to mount.
Type: OP06-15-1.5 NEW Code no.: 006-559-140: with 1.5 m cable
Type: OP06-15-5 NEW
Name
Cable MJ-A10SPF0002-015
MJ-A10SPF0002-050
Bracket 06-021-2112
Mounting Plate 06-021-2111-1
Tapping Screw 5x20
Cosmetic Cap DP-687
Hex. Screw M4x12
Bind Screw M4x10
Mounting plate
Tapping screws (5x20)
Code no.: 006-559-150: with 5 m cable
Type
000-142-878
000-131-411
100-281-880-10
100-279-741-10
000-162-608-10
000-165-997-10
000-162-939-10
000-807-331
5
Fasten the screws to fix
Cable
the bracket.
Insert to the hex.
screws tightened
at step 3.
Code no. Qty
Bracket
Remarks
1 For 1.5 m cable
For 5 m cable
1
1
2
2
4
4 For monitor