Hardware Specifications - Hypertherm SENSOR OHC Manual

Section 1: Overview

Hardware Specifications

Main Power Supply:
Compatible Lifter Motors:
Operating Temperature:
Control Range:
(standard sensor & cable)
Height Measuring Technology:
Accuracy:
(dependent on lifter mechanics)
HF Coax Cable:
Standard Sensor:
Dimensions:
Control Type:
Motor Output:
Control Interface:
Outputs:
Inputs:
Front Panel Indicators
24 VAC +/- 10%, 50/60 Hz
DC permanent magnet motor 24Vdc, 2 Amps to 6 Amps
0 to +50 deg C
Linear 0.1 inch to 1.0 inch (2.5 to 25 mm)
Capacitive Ring with Coax Cable
0.01 inch (0.25 mm) w/ representative Lifter
500 mm to 1500 mm (1000 mm standard)
Stainless Steel Ring 100 mm outer & 50 mm inner
diameters. Can be calibrated for others
8.50"
(216mm) W x 4.21" (107mm) D x 4.02" (102mm) H
Digital Micro Processor based
Full "H" Bridge PWM with current sensing
Optically Isolated I/O on "D" connectors
Digital In-Position Output
Digital Error Output
Digital Plate Contact Output
Digital Manual/Auto Select
Digital Manual Up
Digital Manual Down
Digital Upper Limit Switch
Digital Lower Limit Switch
Digital Second Height Select
Remote Height Set-point Pot
Second Height Set-point Pot
green
yellow
green
yellow
red
Power
Upper Limit Switch
In Position
Lower Limit Switch
Attention/Error Code
5