Table of Contents
Advertisement
Installation
Note
Before installing the CB radio,
visually check the vehicle's
battery connection to deter-
mine which terminal, positive
or negative, is grounded (pos-
itive is the larger of the two)
to the engine block (or chas-
sis). A negatively grounded
vehicle has its negative lead
grounded to the chassis.
Note
Connecting to an accessory fuse
prevents the unit from being left
on accidentally, and also per-
mits operating the unit without
running the engine.
Note
4
In positive ground vehicles the
red wire goes to the chassis and
the black wire is connected to
5
the ignition switch.
Note
When connected to an acces-
sory fuse, unit will self test
the emergency weather alert
automatically when ignition
is turned on. Turns itself on & off.
4
29LXHDLE_MANL.indd 4-5
All manuals and user guides at all-guides.com
In a negative grounded vehicle, connect the
red lead of the DC power cord to an accessory
12 volt fuse.
Connect the black lead to the negative side
of the vehicle. This is usually the chassis. Any
convenient location with a good electrical
contact (remove paint) may be used.
ANT
PA.SP. EXT.SP.
+
–
POWER
6
Plug power cable into back of unit marked
"Power". Be sure to observe polarity markings.
7
Mount the microphone
bracket on either side
of the unit (driver's left)
using two screws sup-
plied. Bracket should be
placed under the dash
so microphone is readily
accessible.
NB/ANL
2
3
NB/ANL
1.5
CAL
SWR
ANL
S/RF
S/RF
RF
SWR
CAL
3
5 7 9
1
SIG
+30dB
SWR/CAL
VOL
SQ
DYNAMIKE
OFF
MIN
8
Attach the 4-pin microphone cable to
receptacle on front of unit and install unit
in bracket securely.
Installation
SCAN
TX
Note
MEM SCAN
RX
If microphone is not
MEM
WX !
connected, audio will not
RF GAIN
DELTA TUNE
T BACK
be heard at speaker.
MIN
MAX
OFF
5
CH 9/
19
ESC
SWR
CAL
9/2/14 3:29 PM
Advertisement
Table of Contents
