Highway Display - Furuno 1824C-BB Operator's Manual

3. PLOTTER OPERATION

3.1.3 Highway display

The highway display, shown in the combination display of radar/compass/highway and
plotter/compass/highway, provides a graphic presentation of ship's track along intended
course. It is useful for monitoring ship's progress toward a waypoint. The own ship marker
shows the relation between ship and intended course. The XTE monitor shows the direction
and amount your vessel is off course – the arrow shows the direction to steer to return to
your course and the numeric the distance you are off course. Using the figure below as an
example, you would steer right 0.009 nm to return to course. To maintain course, steer the
vessel so the own ship marker stays aligned with the intended course line.
Time-to-go
to destination
Destination
waypoint
Soft keys
You can show the soft keys for the highway display by pressing the HIDE/SHOW key.
E: HIWAY CNTRL: On the radar/plotter/compass combination display you can switch
control to the highway display by pressing the E: CNTRL soft key to show HIWAY.
C: EDIT XT-LMT: Sets the range for XTE monitor scale. See the procedure on the previous
page for how to set.
A: RESET XTE: This soft key may be operated to restart navigation, when a destination is
set. Press the C: EDIT XT-LMT soft key followed by the A: RESET XTE soft key. See the
previous page for details.
3-6
Destination
waypoint
Range to destination waypoint
RNG
WPT001
SOG
TTG 0D 9H 59M
WPT001
0.9 nm
0.009nm
Shown (in red) when
direction to steer
is "left."
XTE monitor
Highway display
99.9 nm
10.0 STW 10.0
kt kt
ETA 23th23:59
0.9 nm
Direction to steer
(green)
Speed over ground,
speed through water
Estimated time of
arrival at destination
Intended course
Own ship marker
XTE range