Furuno 1724C Installation Manual page 38

GPS SETUP menu description (con't from previous page)
Item
Fix Mode Choose position fixing method: 2D
(three satellites in view), 2D/3D (three
or four satellites in view whichever is
greater).
Cold Start Clears the Almanac to receive the latest
Almanac.
WAAS setup
Press the WAAS SETUP soft key at the GPS SETUP menu to show the WAAS SETUP
display.
Item
WAAS Mode Select ON to use the WAAS mode.
WAAS WAAS satellite can be searched
Search automatically or manually. For manual
search, enter appropriate WAAS satellite
number.
WAAS Alarm When the WAAS signal is lost, the
audible alarm sounds with the visual
message "NO WAAS SIGNAL."
On: Alarm continues to sound until the
WAAS positioning mode is available
again or the alarm is recognized by key
operation.
Off: Alarm sounds three times.
Corrections Selects the type of message for WAAS
Data correction. Use "00" (operational status)
in North America; "02" in other locations.
31. After you have finished setting up the GPS receiver GP-320B/330B, it's now time to set
up external equipment. Press the NEXT soft key to show the DATA1 (GPS/NMEA) port
setup menu. It is only necessary to set up ports which you are going to use; skip
unnecessary steps. If you do not have external equipment connected to the NavNet,
press the NEXT key several times to show the "FINISH AND EXIT INSTALLATION
WIZARD" screen and then push the ENTER knob to finish.
OUTPUT FORMAT
NMEA0183 2.0
BAUD RATE
4800bps
LAT/LON FORMAT
DD°MM.MMM'
XTE FORMAT
X. XX
OUTPUT DESTINATION
NO
Installation wizard, DATA1 (GPS/NMEA) port setup menu
Description
Contents of WAAS SETUP menu
Description
30
Settings Default Setting
2D, 2D/3D 2D/3D
No, Yes No
Settings Default Setting
On, Off Off
Auto, Manual Auto
On, Off Off
00 to 27, 99 02