Optional Speed/Water Temperature Sensor St-02Msb, St-02Psb - Furuno GP-7000F Installation Manual

1.4 Optional Speed/Water Temperature Sensor
ST-02MSB, ST-02PSB
1. Dry-dock the boat.
2. Make a hole of approx. 51 mm diameter in the mounting location.
3. Unfasten locknut and remove the sensor section.
4. Apply high-grade sealant to the flange of the sensor.
5. Pass the sensor casing through the hole.
6. Face the notch on the sensor toward boat's bow and tighten the flange.
7. Set the sensor section to the sensor casing and tighten the locknut.
8. Launch the boat and check for water leakage around the sensor.
Speed/water temperature sensor ST-02MSB, ST-02PSB
Face "notch"
toward bow.
Flange Nut
Coat with
Brim
silicone sealant.
18
Locknut
51
123
Unit: mm
φ77