Electronically published by Chauvet in the United States of America. CHAUVET, the Chauvet logo, Geyser P6 and Geyser are registered trademarks or trademarks of Chauvet & Son, LLC. (d/b/a Chauvet and Chauvet Lighting) in the United States and other countries. Other company and product names and logos referred to herein may be trademarks of their respective companies.
P6 Make sure you use FCQ regularly, waiting no longer than 90 days between cleanings, to increase the life of your fogger. The Geyser P6 was specifically designed for use with CHAUVET Quick Dissipating Fluid (QDF). For optimum performance with your fogger, Chauvet recommends using QDF.
2. I NTRODUCTION Overview Fluid Tank Removable Shield Nozzle and LEDs Handles Control LED Display Buttons On/Off Switch DMX In/Out Power In Remote Control Fuse Holder Receiver Port Geyser P6 User Manual Rev. 3 Page 5 of 18...
ETUP AC Power The Geyser P6 has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s panel, or refer to...
Notes. Orientation Primarily, the Geyser P6 is to be floor mounted in a vertical fog jet orientation. Alternatively, it may also be mounted in a floor mounting/horizontal fog jet orientation or in an overhead mounting/downward fog jet orientation; however, be sure to follow instructions closely to avoid tank spills with alternate mountings.
Page 9
With inverted mounting, avoid spillage of the fog fluid by setting the fluid tank in an upright position. Be sure to use a safety cable for both the Geyser P6 and the fluid tank when rigging in this manner. Follow the instructions provided to reverse fluid tank compartment.
Attach the removable plate to the opposite side and secure the tank with the bottle lock. Secure both the bottom plate and tank cover with the screws. *Actual product may vary slightly from drawing Page 10 of 18 Geyser P6. User Manual Rev. 3...
DMX mode uses. If you choose a starting address that is too high, you could and Starting restrict the access to some of the product’s channels. Address The Geyser P6 uses up to 10 DMX channels in a 10CH DMX mode, which defines the highest configurable address as 503. familiar with...
Page 12
010 ó 255 Speed, slow to fast 000 ó 009 No function Strobe 010 ó 255 Strobe, slow to fast 000 ó 002 No function Dimmer 003 ó 255 0–100% Page 12 of 18 Geyser P6. User Manual Rev. 3...
Geyser P6 On the wireless transmitter, press the button assigned to the color program (1–4). The Geyser P6 emits fog and activates the color program for as long as you hold down the button. Geyser P6 User Manual Rev. 3...
Refill with fog fluid. Run the machine briefly to clear any cleaning solution from the pump and heater. Fog Cleaner Quart (FCQ) was specifically developed by Chauvet to clean your Geyser P6 Use FCQ regularly, waiting no longer than 90 days between cleanings, to increase the life of your fogger. Storage/ Before storing the fogger, run FCQ through the system as described in the cleaning procedure above;...
Fogger Maintenance. Refill with CHAUVET® water-based fog fluid. Wired remote Make sure that the remote is connected disconnected or Try the remote on another Geyser P6 if defective available “Addr” or “HEAT” Inappropriate wired Wireless Remote Control for instructions...
Be sure to pack the product properly. Any shipping damage resulting from inadequate packaging will be your responsibility. FedEx packing or double-boxing are recommended. Chauvet reserves the right to use its own discretion to repair or replace returned product(s). Geyser P6 User Manual Rev. 3 Page 17 of 18...