Furuno FAX-408 Operator's Manual page 26

2. MAINTENANCE
7. Turn on the power.
8. Press the 0 key until the sheet feeds out 5-15 cm.
9. Set the paper release lever downward and remove the head cleaning sheet and paper sensor
jig.
10.Re-set the roll paper, paper compartment cover and paper cutter.
Paper release lever
!
Paper sensor jig
Paper stopper
Note: Do not use the head cleaning sheet more than once per cleaning session and do not use a
sheet whose grade is coarser than #2000. A coarser grade will damage the thermal head.
If the recording is still dirty
Turn off the power. Moisten a cotton swab with ethyl alcohol and insert between the thermal head
and rubber roller, until about 4 mm of the swab is inserted. Move the swab to clean. USE ONLY
ethyl alcohol to clean.
Use only a slight amount of ethyl alcohol. Excessive amount may dissolve corrosive components
in printing chaff, which can damage the thermal head. Further, be sure the alcohol has dried com-
pletely before turning on the power.
2.2 Replacement of Recording Paper
Use only the recording paper specified by FURUNO. Use of other recording paper may degrade
performance, damage the thermal head and prevent detection of "paper out".
When the paper is nearly out, the message PAPER OUT!! appears on the display and recording
is automatically stopped. When about 3 m of paper remains, a red line of 2-3 mm in width begins
to appear on the paper. When this happens, replace the paper as shown in the procedure on the
next page.
Part name Type Code No.
Recording paper TP-0820B 000-157-755-10
16