Table of Contents
Advertisement
CD PLAYER ADJUSTMENTS
4. ADJUSTMENTS
M e a s u r i n g
A d j u s t m e n t
i n s t r u m e n t
I t e m
(a) Tracking
Oscilloscope
balance
(b) Checking
the "eye"
Oscilloscope
pattern
(1)Tracking balance adjustment
1. Connect an Oscilloscope to TP3 (TE) and TP4(VC).
2. Turn "POWER" switch on.
3. Set the test disc.(DISC 1)
4. Press "SOUND PRESET" key and "TUNING MODE" key
simultaneously .Within 1 second after pressing the
"MEMORY" switch.
(SERVICE MODE
Tracking balance adjustment mode)
5. Confirm that the oscilloscope waveform is symmetrical on
the top and bottom in relation to OV(VC).
6. If it cannot be adjusted by fully rotating VRlOl, cut the
resistor R1108 (1 Ok R
again.
7. To cancel service mode, disconnect the power cord's plug
from the electrical outlet.
(2)Checking the "eye" pattern
1. Switch "ON" the POWER.
2. Connect an oscilloscope to TPl (RF) and TP4(VC).
3. Load the test disc.
4. "PLAY/PAUSE" switch push ON.
5. Check to be sure that the "eye" pattern is at the center
ofwaveform and that the diamond shape is clearly defined.
6. Press the "STOP" button.
7. Switch "OFF" the POWER.
All manuals and user guides at all-guides.com
S e r v i c e
mode
with a pair of pliers,and adjust
o u t p u t
A d j u s t m e n t
location
connection
TP3
TE
TR4
VC
RF
TP4
VC
T E
Adjustment value
Waveform symmetry
A=B
Check be sure that the "eye"
pattern is at the center of the
waveform and that the diamond
shape is clearly defined
Advertisement
Table of Contents
