Page 1
60-105 1HP Portable Dust Collector with Wall Mount Operator’s Manual Record the serial number and date of purchase in your manual for future reference. Serial Number: _________________________ Date of purchase: _________________________ For technical support or parts questions, email techsupport@rikontools.com or call toll free at (877)884-5167 www.rikontools.com...
Changes and improvements may be made at any time, with no obligation on the part of Rikon Power Tools, Inc. to modify previously delivered units. Reasonable care has been taken to ensure that the information in this manual is correct, to provide you with the guidelines for the proper safety,...
SAFETY INSTRUCTIONS IMPORTANT! Safety is the single most important consideration in the operation of this equipment. The following instructions must be followed at all times. Failure to follow all instructions listed below may result in electric shock, fire, and/or serious personal injury. There are certain applications for which this tool was designed.
Page 4
SAFETY INSTRUCTIONS 12. KEEP PROTECTIVE GUARDS IN PLACE AND IN 25. ALWAYS WEAR A DUST MASK TO PREVENT WORKING ORDER. INHALING DANGEROUS DUST OR AIRBORNE PARTICLES, including wood dust, crystalline silica dust 13. AVOID ACCIDENTAL STARTING. Make sure that and asbestos dust. Direct particles away from face and the power switch is in the “OFF”...
SAFETY INSTRUCTIONS EXTENSION CORDS ELECTRICAL SAFETY THE USE OF AN EXTENSION CORD THIS TOOL MUST BE GROUNDED WITH THIS MACHINE IS NOT RECOMMENDED. For WHILE IN USE TO PROTECT THE OPERATOR FROM best power and safety, plug the machine directly into a ELECTRIC SHOCK.
SAFETY INSTRUCTIONS SPECIFIC SAFETY INSTRUCTIONS FOR DUST COLLECTORS This machine is intended for the collection of chips, shavings and dust from the surfacing, cutting and sanding of natural wood, plywood, plastics and other man-made wood based composites. It is for collecting DRY materials only.
( not shown ) Handle & Hardware for Funnel Model 60-105 1HP Portable Dust Collector is shipped complete in one box. Unpacking and Clean-up 1. Carefully remove all contents from the shipping carton. Compare the contents with the list of contents to make sure that all of the items are accounted for, before discarding any packing material.
NOTE: The Dust Bag does NOT have to be removed The 60-105 Portable Dust Collector can be used from the machine for emptying when it becomes filled with or without the vertical arm Support Pipes and with sawdust and shavings.
Page 9
ASSEMBLY INSTALL THE 4” DUST HOSE Locate the 4” Hose (#17) and two 4” Hose Clamps (#16). 1. Slip a hose clamp (A) over both ends of the hose. 2. Place one end of the hose over the 4” inlet on the fan’s Housing Cover (#20) and tighten the hose clamp with a slotted screwdriver or wrench.
Page 10
INSTALL THE WALL MOUNTING BRACKET FOR HANGING THE DUST COLLECTOR FOR USE FIG. 9 The 60-105 Portable Dust Collector includes a bracket for mounting the collector onto a wall for dedicated use to a machine, work area, bench, or for storage.
NOTE: For permanent dust collector set-ups, the following instructions are recommended. For the occasional use of the 60-105 Portable Dust Collector, care must none-the-less be taken to keep the hose and bag clean. Dust particles moving through flexible or rigid plastic duct work can cause static electricity build-up. The duct work must be properly grounded to ensure that static discharge does not ignite fine dust particles causing an explosion or fire.
PARTS DIAGRAM 60-105 PORTABLE DUST COLLECTOR NOTE: Please reference the Key Number when calling for Replacement Parts. For Parts under Warranty, the Serial Number of your machine is required.
WIRING DIAGRAM 115V 60Hz This machine must be grounded. Replacement of the power supply cable should only be done by a qualified electrician. See page 5 for additional electrical information. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION 1. Plug cord into electrical outlet. 1.
® RIKON Power Tools Inc. (“Seller”) warrants to only the original retail consumer/purchaser of our products that each product be free from defects in materials and workmanship for a period of five (5) years from the date the product was purchased at retail.
Page 16
60-105 For more information: 25 Commerce Way North Andover, MA 01845 877-884-5167 / 978-528-5380 techsupport@rikontools.com LINK TO RIKON WEBSITE www.rikontools.com 60-105M3...