Setting The Scsi Id - Fujitsu C150-E140-03EN Operation Manual

2.3.4 Setting the SCSI ID

This section explains how to set the SCSI ID.
Set the SCSI ID as follows:
1) Disconnect the power cable from the outlet.
2) Set the device address using the SCSI ID switch on the back of the
Notes concerning device address setting
Address No.
0 to 7 These address numbers can be set.
8, 9 The factory default value (SCSI ID = 5) is used for these numbers.
3) After setting the address number corresponding to the target SCSI ID,
2-8
image scanner.
connect the power cable to the outlet.
Meaning
M3091DC Image Scanner Operation Guide