Table of Contents
Advertisement
5) Adjust the document guides to the document width, then straighten
6) Specify a copy count using the Function button.
7) Adjust the copy density using the copy density dial, as required.
8) Switch to reading mode by pressing the Duplex button.
9) Press the Send to button on the scanner.
10) After finishing reading, remove the documents from the stacker.
3-10
the documents.
If the documents are placed loosely between the left and right guides,
they may be read diagonally.
When the Function No. display panel is ON, the single-side reading
mode is active.
When the Function No. display panel blinks, the double -sided reading
mode is active.
The set documents are read and output from the printer.
u Key point
Press the Send to button to start the application software. The
mark is displayed until the application starts.
If the application software does not start and the Function No.
display panel displays the Function No. again, copy processing is
canceled.
M3091DC Image Scanner Operation Guide
Advertisement
Table of Contents
