U-Line S-24402 Instructions Manual

S-24402
3M VENTED HARD
HAT WITH UVICATOR™
WARNING! 3M H-700 Hard Hat provides LIMITED
head protection only. Misuse or failure to follow
warnings and user instructions may result in
serious personal injury or death. For proper
use, see supervisor, instructions or call Uline
Customer Service at 1-800-295-5510.
• This hard hat is designed to provide limited head
protection from small falling objects, such as small
tools, nuts and bolts, etc., striking the top of the
hard hat.
• Do not use for protection against larger objects,
severe impact or penetration, or for objects
traveling at accelerated speeds – avoid areas in
which these may be present.
• Do not rely on the hard hat to provide front, side or
rear impact protection.
• If the hard hat has sustained impact, dispose of it
immediately, even if damage is not visible.
• The hard hat must fit securely on the head and
suspension must be adjusted to a snug fit.
• Never alter, puncture, modify or engrave the shell
or the suspension.
• Do not use paints, solvents, chemicals, adhesives,
gasoline or like substances on this hard hat – doing
so can lessen the protection from impact and
penetration.
ELECTRICAL WARNING: Avoid areas where
the chance of severe electrical shock exists.
Vented helmets do not meet Class G (General)
or Class E (Electrical) requirements and provide
no electrical protection. Non-vented versions
meet Class G and E requirements as providing
limited electrical protection.
PAGE 1 OF 12
1-800-295-5510
uline.com
SAFETY
• Do not use this hard hat as a vehicular or
recreational hard hat.
• Do not store objects between the suspension
and the shell, as the hard hat will not function
as intended, and user will receive less head
protection.
• Exposure to direct sunlight and heat over time
can lessen the ability of the hard hat to withstand
impact and penetration. When possible, store hard
hat out of direct sunlight, including the dashboard
or rear window shelf of a vehicle, and extreme heat
over 120°F.
• Inspect the hard hat, including the suspension
and shell, before and after each use. Replace the
hard hat immediately if it shows any signs of wear,
damage, abuse or degradation. This may be a
sign that protection is reduced.
• Do not use by an open flame.
• Keep plastic bag out of the hands of infants and
children. It is not a toy, and infants and children
should not play with the bag. Wrapping of the bag
around or over the head can cause serious injury
or death.
3M hard hats meet ANSI/ISEA Z89.1-2014 Type I
requirements and CSA Z94.1-15 Type 1 requirements.
• Non-Vented Class G and E hard hats meet the
requirements of ANSI/ISEA Z89.1-2014 and CSA
Z94.1-15 as providing limited electrical protection.
• Vented Class C hard hats provide no electrical
protection.
Para Español, vea páginas 5-8.
Pour le français, consulter les pages 9-12.
CAUTION! Only 3M Hard Hat Accessories used
in conjunction with 3M Hard Hats have been
tested to applicable safety standards.
0921 IS-24402