Cleaning The Ac 3 - Sennheiser AC 3 Instruction Manual

Cleaning the AC 3

CAUTION!
Setting the AC 3 to standby mode
Press the STANDBY
The operation indicator
The AC 3 switches to standby mode. Connected transmitters
are switched off, provided that they are powered via the BNC
sockets RF IN 1
Disconnecting the AC 3 from the mains
The STANDBY button
mains. To disconnect the AC 3 from the mains:
Unplug the NT 3-1 table top power supply from the wall
socket.
The AC 3 is switched off.
Cleaning the AC 3
Liquids can damage the electronics of the device!
Liquids entering the housing of the device can cause a short-
circuit and damage the electronics.
Keep all liquids away from the device.
Do not use any solvents or cleansing agents.
Before cleaning, disconnect the AC 3 from the mains
(see page 13).
Only use a slightly damp cloth to clean the device.
³
button for approx. 2 seconds.
·
and the 4 status LEDs
².
to RF IN 4
³
does not disconnect the AC 3 from the
»
go off.
AC 3 | 13