Table of Contents
Advertisement
Steps
1. Place the heat sink on the system board.
2. Tighten the four captive screws that secure the heat sink to the system board.
NOTE:
Tighten the captive screws in the sequential order mentioned on the heat sink [1 > 2 > 3 > 4].
NOTE:
The number of screws varies depending on the configuration ordered.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Removing the heat sink - discrete
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
The following images indicate the location of the discrete heat sink and provide a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
45
Advertisement
Table of Contents
