Install Your Cb6000 - FrontRow CB6000 Installer's Manual

Step 6:
Estimated time for this step: 15 minutes
With the positions and programming of all your major components settled, you can now install your CB6000s. Refer to
the examples in Step 1 as you connect components.
1. Install a double-gang electrical box, surface box, or mud ring according to the manufacturer's instructions
2. If using the CB6000 with a FrontRow ICR-01 Smart Receiver or CM3000 amplifier/switch (as in a full ezRoom system):
• Thread Cat 5 cable from the electrical box to the location of the FrontRow ICR-01 Smart Receiver or CM3000.
Ensure the cable is installed in compliance with your national and local electrical codes.
• Connect the Cat 5 cable to the CB6000's Network jack
WARNING: CONNECT TO THE CB6000'S "NETWORK ONLY" JACK! YOU CAN
DAMAGE YOUR DEVICES IF YOU CONNECT TO THE "AUX" JACK.
• If you are controlling a serial device (e.g., projector), connect the provided serial cable(s) to the ICR-01 Smart
Receiver's RS232 connector or the CM3000's COM1 captive screw connector. Wiring is as follows:
• Black (ground) to GND
• Red (input to device) to TX1
• White (output from device) to RX1
IMPORTANT: Be sure to keep wiring and Action commands consistent to avoid
problems. For example, serial Actions sent to COM1 should use the TX1/RX1 pins.
(See Appendix A).
ICR-01 Smart Receiver
• If you are controlling a device via infrared (e.g., a DVD player), connect an IR emitter cable (not included; part
number 520-3001-001) to the ICR-01 Smart Receiver's IR blaster port. Secure the emitter end to the controlled
device's infrared sensor.
• Connect the Cat 5 cable to the CB2000 / CB6000 jack on the ICR-01 Smart Receiver
CM3000
3. If using the CB6000 with a FrontRow Soundpost:
• Thread Cat 5 cable from the electrical box to the location of the FrontRow Soundpost. Ensure the cable is
installed in compliance with your national and local electrical codes.
• Connect the Cat 5 cable to the CB6000's Network jack
WARNING: CONNECT TO THE CB6000'S "NETWORK ONLY" JACK! YOU CAN
DAMAGE YOUR DEVICES IF YOU CONNECT TO THE "AUX" JACK.
• If you are controlling a serial device (e.g., projector), connect a Cat 5 cable between the Soundpost's AUX1
RJ45 jack and a TB232 adapter (not included; part number 600-10-2001). Connect the TB232 adapter to the
controlled device's serial port.
• Connect the Cat 5 cable to the CLAN jack on your Soundpost

Install your CB6000

15