Table of Contents
Advertisement
dummyhead
dummyhead
BEFORE OPERATION CHECK
NOTE: Before beginning the checks, be sure the power pack is on a level
surface and stopped. Also, perform a test run during the checks.
BEFORE ATTACHING THE BATTERY PACK
Check the following:
– Exterior covers [1] for damage
– Power cable [2] for damage or any foreign material in battery connector
– Motor wire harness [3] for damage
– Battery fastener [4] for deflection or damage
– Battery mount rubbers [5] (4 places) for wear or damage
– Battery hook [6] for deformation or damage
NOTE: Replace each part in accordance with the maintenance schedule.
WHEN ATTACHING THE BATTERY PACK
NOTICE
: Ensure the battery pack is securely installed so it does not come
loose during operation or become damaged.
Check the setting condition of the battery pack and If it feels loose, the
fastening components must be checked (page 5-3).
DURING THE TEST RUN
Check that the following:
– All indicators [7] light (when the power pack is turned on)
– All switches [8] work (start and stop) properly
WIRE HARNESS CHECK
Remove the under frame (page 6-4).
Check each connecting part of the wire harnesses for looseness or
damage.
Replace the wire harness or the related part if necessary.
DRAIN HOLE CLEANING
Clean around the drain hole [1] to remove dirt, debris, or foreign objects.
MOTOR SET SPEED CHECK
The rotational speed of the motor is set at constant speeds.
Check that there is no malfunction or unusual sound in each setting speed
by rotating and stopping the motor.
If any abnormality is found, follow the troubleshooting (page 4-2).
[4]
[5]
[2]
[8]
[7]
[1]
[1]
MAINTENANCE
[6]
[3]
3-3
Advertisement
Table of Contents
