Cabling And Rear Panel Views; Inputs - Extron electronics SW RGBHV Series User Manual

Cabling and Rear Panel Views

All connectors are on the rear panel. The switcher can be connected to up to six
RGBHV or component video devices and (audio models only) stereo audio devices,
depending on the model. The video and/or audio output output is identical to the
selected input; the switchers perform no sync or video format manipulation.
SW 2 models are in half-rack width enclosures and the rest of the models are in full-
rack width enclosures. Figure 2-5 shows an SW2 RGBHV video switcher.
Figure 2-6 shows an SW4 RGBHV A video and audio switcher. The two switchers
shown have all of the connector configurations that are available in the SW RGBHV
product family covered in this manual.
Switchers with video capabilities can switch video and audio separately (audio
breakaway).
100-240V 1.3A
50-60Hz
6
Figure 2-5 — SW2 RGBHV video switcher
100-240V 1.3A INPUT 1
H/HV
R G B V
INPUT 2
50-60Hz
6
Figure 2-6 — SW4 RGBHV A switcher with audio

Inputs

1
Figure 2-7 — Video input and output connections
Tighten the screws.
c.
d. Replace the switcher on the underside of the surface (step 6).
INPUT 1
H/HV
B V R
R G
INPUT 2
1
1
INPUT 3
H/HV
R G B V
INPUT 4
RGB and component video inputs — For each input, connect an RGBHV,
RGBS, RGsB, RsGsBs, or component video source to these BNC connectors.
Connect the cables as shown in figure 2-7.
RGBHV
G
RGBS
R G
RGsB,
RsGsBs
Component
R G
SW RGBHV Series Switchers • Installation
5
REMOTE
G H/HV V
B
AUTO
MANUAL
OUTPUT
3
2
INPUTS
1 2 3
L R L R L
G
R
B
OUTPUT
3
H/HV
V
B
H/HV
V
B
H/HV
V
B
4
OUTPUT
4
R L R
L R
REMOTE
AUTO
H/
V
MANUAL
HV
5
2-7