Table of Contents
Advertisement
en Shelf supports
Pull the rail out towards the front until the retainer at
3.
the back unhooks.
Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 17
17.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
Insert the pull-out rail between the two bars.
1.
22
Push the retainer
2.
upper bar.
Keep the PUSH tab pushed in
3.
out rail inwards until the front retainer
between the two bars
Release the PUSH tab.
‒
a The retainer
clicks into place.
Pull the pull-out rail out as far as it will go and slide
4.
it back in.
in between the lower and the
and swing the pull-
is located
.
Advertisement
Table of Contents
