Advertisement
Installation
A. Prepare frame and door.
1.
Using templates supplied with double swing
hinge and emergency release stop products,
prepare door and frame. (Figure 1)
NOTE: These instructions illustrate
the Markar DSH1000 hinge and the
Pemko DSHP01 hinge with Pemko ERS
or ERSMP stop. For comprehensive
information about those products,
please visit assaabloydooraccessories.
us. For other manufacturers' hinge and/
or stop products, please consult Rixson
Support for templating and installation
modifications.
2.
Using template provided with these
instructions, prepare frame header and door
for closer. (Figure 2)
3.
Confirm all cutout dimensions for closer.
NOTE: Closer is installed centered to closed
door. Depending on application, it may not
be centered in width of frame header.
B. Install wood mounting clips.
1.
Drill pilot holes into frame.
2.
Install clips with four (4) #14 x 1-1/2" wood
screws. (Figure 3)
C. Install hinge and emergency release stop.
1.
Verify frame is square and plumb.
2.
Using manufactures' installation instructions,
mount hinge and frame stop supplied by
others.
3.
Mount door to leave 3/32" (2) gap between
top of door and frame header. (Figure 4)
NOTE: Door should swing freely.
4
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2021-10-20
Model W73ER, Wood Frame
Markar DHS1000
Double Swing Hinge
Figure 1
Wood Frame
Figure 2
Figure 3
Pemko Emergency
Release Stop
Top of Door
3/32
(2)
Figure 4
ISW73ER Rev 1 10/21
Advertisement
