Sony SEL1635GM Service Manual page 69

3. When the ENTER key is pressed, message screen is displayed
in the following. Set the zooming ring to the WIDE end (focal
length: 16 mm).
Zooming ring
4. When the ENTER key is pressed, message screen is displayed in
the following. Set the flange back adjustment jig on the subject.
5. When the ENTER key is pressed, automatic adjustment is started.
6. After the automatic adjustment is completed, message screen
is displayed in the following. Set the siemens star chart on the
subject.
7. When the ENTER key is pressed, automatic adjustment is started.
8. After the automatic adjustment is completed, message screen is
displayed in the following.
9. Rotate the zooming ring to the TELE side until the background
color of the value (hexadecimal number) at the lower left of the
window changes to light blue.
* The bar and value (hexadecimal numeral) under the window are
displayed by interlocking with the behavior of the zooming ring.
* A green line is displayed on the bar under the window as a refer-
ence of the setting.
10. When the ENTER key is pressed, message screen is displayed in
the following. Set the flange back adjustment jig on the subject.
11. When the ENTER key is pressed, automatic adjustment is started.
12. After the automatic adjustment is completed, message screen
is displayed in the following. Set the siemens star chart on the
subject.
13. When the ENTER key is pressed, automatic adjustment is started.
14. After the automatic adjustment is completed, message screen is
displayed in the following. Set the zooming ring to the TELE
end (focal length: 35 mm).
Zooming ring
5-31
SEL1635GM
– Continued on next page –