Sony SEL1635GM Service Manual page 67

Fe 2.8/16-35 gm) (fe 16-35mm f2.8 gm)
Table of Contents

Advertisement

10. Rotate the zooming ring to the TELE side until the background
color of the value (hexadecimal number) at the lower left of the
window changes to light blue.
* The bar and value (hexadecimal numeral) under the window are
displayed by interlocking with the behavior of the zooming ring.
* A green line is displayed on the bar under the window as a refer-
ence of the setting.
11. When the ENTER key is pressed, automatic adjustment of POS2
is started.
12. After the automatic adjustment of POS2 is completed, "ZOOM
- POS3" is displayed.
13. Repeat the operations from step 10 to step 12 to "POS8".
14. After the automatic adjustment of POS8 is completed, message
screen is displayed in the following. Set the zooming ring to the
TELE end (focal length: 35 mm).
Zooming ring
15. Rotate the zooming ring to the WIDE side until the background
color of the value (hexadecimal number) at the lower left of the
window changes to light blue.
16. When the ENTER key is pressed, automatic adjustment of POS9
is started.
17. After the automatic adjustment of POS9 is completed, "ZOOM
- POS10" is displayed.
18. Repeat the operations from step 15 to step 17 to "POS15".
19. After the automatic adjustment of POS15 is completed, message
screen is displayed in the following. Set the zooming ring to the
WIDE end (focal length: 16 mm) and press the ENTER key.
Zooming ring
20. "Resonance Noise Check START" is displayed, press the ENTER
key.
21. Checked that abnormal noise from a lens is not heard, press the
ENTER key.
Note: If abnormal noise is heard, replace the 2 group block assy
and adjust again.
22. "Actuator_Damage Check CHECK OK" is displayed.
23. When the ENTER key is pressed, recording the adjustment data
and releasing from adjustment mode are performed automatically,
and "FINISHED" is displayed when the process is completed,
then click the [OK] button.
5-29
SEL1635GM

Advertisement

Table of Contents
loading

Table of Contents