EverFocus EDVR SERIES Instruction Manual page 109

Connection Procedure:
1. The First step is to purchase or make a straight through cable. We recommend
purchasing one if you have never made a straight through cable. Please remember
you can not use a cross over network cable for this application
2. Once you have a straight through cable plug one end into the LAN port on the back of
the recorder and the other into the router.
3. Now Log into the DVR menu and using the jog dial from the previous chapter go to
the Network Setting Menu.
4. If you have a Linksys Router:
Assign an IP address of 192.168.001.050 to the DVR, a Subnet mask of
255.255.255.000, and a default gateway of 192.168.001.001.
If you have a D-Link Router:
Assign an IP address of 192.168.000.050 to the DVR, a Subnet mask of
255.255.255.000, and a default gateway of 192.168.000.001.
If you have a pre-existing LAN:
Go to a Computer on the pre-existing network and do the following:
o Go to Start, then Run and type cmd and click on OK.
Then hit enter, type ipconfig and press enter this will give you the information
you will need.
99