Wi-Fi Protected Setup - D-Link DWR-116 User Manual

Section 3 - Configuration
If you choose WPA-Enterprise, the following options will appear:
WPA Mode: Select whether to use WPA2 only or WPA only.
WPA2 only is the most secure, provided that all
of your clients can support it.
Cipher Type: Select whether to use the TKIP or AES cipher. The
AES cipher is the most secure, provided that all of
your clients can support it.
RADIUS Server IP Enter the IP address of your RADIUS server.
Address:
RADIUS Server Enter the port used for your RADIUS server.
Port:
RADIUS Server Enter the shared secret/password for your RADIUS
Shared server.
Secret:
D-Link DWR-116 User Manual
Section 3 - Configuration
Wi-Fi Protected Setup (WPS) System is a simplified method for
securing your wireless network during the "Initial setup" as well
as the "Add New Device" processes. The process is just as easy as
pressing a button for the Push-Button Method or correctly entering
an 8-digit code.
Enable: Enable/disable the Wi-Fi Protected Setup feature.
AP PIN: Shows the current PIN.
Generate New Create a random number that is a valid PIN. This
PIN: becomes the router's PIN. You can then copy this
PIN to the user interface of the wireless client.
Config Mode: Select whether the router is the Enrollee or the
Registrar. If this is set to enrollee, the router will
try to connect to other devices. If it is set to registrar, other devices will try to connect to the router.
Config Status: Displays the current state of WPS configuration. Clicking the Release button will disable any previously paired devices from connecting.
You will need to reconfigure WPS on those devices to connect them again.
Disable WPS-PIN This checkbox will disable pin authentication for WPS. You will have to use the push button on the router and the device you are
Method: trying to connect in order to establish a WPS pairing.
Config Method: Select whether the WPS authentication will use Pin code or push button method.
WPS Status: Displays the current state of the router's WPS system.
Trigger: The Trigger button acts like the physical WPS push button, and will search for devices nearby that are trying to establish a WPS
connection.
Note: The DWR-116 has a WPS push button on the front panel that will activate WPS mode by pressing and holding the button
for approximately 6 seconds. The Wi-Fi LED will begin to flash rapidly when WPS mode has been activated.
31 D-Link DWR-116 User Manual

Wi-Fi Protected Setup

32