Setup; Internet Connection Setup Wizard - D-Link DWR-116 User Manual

Section 3 - Configuration

Internet Connection Setup Wizard

The setup wizard guides you through the initial setup of your router.
There are two ways to setup your Internet connection. You can use the
Web-based Internet Connection Setup Wizard or you can manually
configure using the Manual Internet Connection Setup wizard.
This wizard will guide you through a step-by-step process to
configure your D-Link router to connect to the Internet.
Click Internet Connection Setup Wizard to begin.
If you want to enter your settings without running the wizard, click
Manual Internet Connection Setup and skip to page "Manual
Internet Connection Setup" on page 16.
D-Link DWR-116 User Manual

Setup

Section 3 - Configuration
Create a new password that will be used to access the router and
then click Next to continue.
Click Prev to go back to the previous page or click Cancel to close
the wizard.
Select your time zone from the drop-down box and then click Next
to continue.
Click Prev to go back to the previous page or click Cancel to close
the wizard.
Select the Internet connection type. The connection types are
explained on the following page. If you are unsure of the correct
connection type, you may have to contact your Internet Service
Provider (ISP).
Click Prev to go back to the previous page or click Cancel to close
the wizard.
Note: The DWR-116 supports several kinds of WAN interfaces, allowing
you to assign either a WAN or a WWAN(3G/4G LTE) connection as the
backup WAN. If the Primary WAN is down or unavailable, configure
the backup WAN to Enable, and all the traffic will be routed through
backup WAN. This feature is called WAN Failover. You can use WAN
Failover if you need redundancy to your Internet connection or any
other network.
9 D-Link DWR-116 User Manual 10