Hemming; Sewing Blind Hems - Euro-Pro 372 Instruction Manual

HEMMING

(Model 377 only)
Presser foot
Pattern selector
Stitch length dial
Raise the foot and the needle to its highest position. Replace the
foot with the hemmer foot.
Fold over the fabric edge by about 3mm (1/8 inches ) and place it
under the foot. Secure the folded edge with a few stitches. Take
out the workpiece and draw the hem into the hemmer foot by
pulling on the threads.
Lower the foot and swe the hem.
During sewing, fold the fabric to the left a little and allow it to
run into the hemmer foot.
Make sure that the fabric does not move under the right half of
the foot. The fabric must be fed into the scroll of the hemmer
sufficiently so that the workpiece edge runs freely
groove under the foot.

SEWING BLIND HEMS

Model 377
Presser foot blind hem foot
B (
Pattern selector
1 to 3
Stitch length dial
1. Turn up the hem to the desired width and press. ( Fig. 1)
2. Fold hem back against the right side of the garment with
top edge of hem extending about 4 mm (1/6 inches)
right side of the garment folded. (Fig. 2)
3. Place the garment under the foot so that double-folded edge
runs along the hemlguide and lower the foot.
Sew slowly for better
zigzag stitches are sewn on the hem edge and wide zigzag
stitches will just catch one thread of folded edge. (Fig. 3)
4. Unfold the fabric and you will have a bling
(Fig. 4)
hemmer foot
M( )
1 to 4
(Model 377/374/373/372)
Model 374 Model 373/372
blind hem foot
) E( )
1 to 3
control, making sure the narrow
stitch hem
through the
to the
16
hemmer foot
3mm
(Fig. 1)
, ,
4mm (1/6 )
(Fig. 2)
Guide
adjusting
(Fig. 1)
screw
Guide
Foided edge
(Fig. 3)
(Fig. 4)