1 Introduction Original user instructions These instructions are FKI Fast Food Teknik's original instructions for Roller Grill GLxRxxxx. The purpose of these instructions These instructions are intended to ensure the correct installation, use, handling and maintenance of the Roller Grill.
Appliance label 1.1.3.1 Type code: SRG-97 Technical specifications and power consumption Explanation of the Roller Grill product name: Appliance designation: GL 6R T A O S 45 / 2 The Roller Grill’s full designation is Grill Line Number of rollers e.g. 6 rollers Teflon coated rollers Aluminium rollers Oval rollers...
Page 5
GL 6R 22 300 x 265 x 170 mm GL 6R 45 530 x 265 x 170 mm GL 6R 65 725 x 265 x 170 mm GL 6R 102 1100 x 265 x 170 mm GL 8R 22 300 x 350 x 170 mm GL 8R 45 530 x 350 x 170 mm GL 8/5RT45/2...
These instructions and the appliance itself are provided with important safety information that must always be read and observed at all times. FKI Fast Food Teknik a/s disclaims any and all liability for non- compliance with these safety instructions, for inappropriate use of the appliance or the use of incorrect set- tings.
It is recommended that gloves and goggles are worn when working with the appliance and when emptying the grease tray, as the roller grill has hot surfaces and hot grease can be dangerous. Potential hazards When the appliance is in use, the user should be aware that the appliance is hot. Take particular care not to touch the rollers without wearing protective gloves.
Transport/installation/fixation Transport The appliance is delivered secured to a transport pallet, and should only be transported in the same way if moved. WARNING: Do not move the appliance during operation. Moving and setting up the appliance must be performed by two or more peo- ple! RISK of injury! Wear protective gloves and safety footwear during unpacking and installation.
Installation Place the appliance on a suitable table top or similar at an appropriate working height. The appliance is op- erated from the front. The appliance has adjustable legs and is intended for placement on a table or coun- ter. Connection of the appliance should be carried out by an authorised electrician.
Operation The appliance must be supervised during use and must be switched off at its main switch if left. The appliance is intended for food preparation only. Do not apply liquids or other substances with a focal point below 300°C. Temperature on appliances with Teflon-coated tubes must not exceed 250°C peak and 220°C continuous.
3 Operation Before first use Before start-up, remove all packaging and protective plastic from the appliance and dispose of it in accordance with currently applicable regulations (see section 5). Carefully read section2 about safety before connecting the appliance. Before start-up, clean the appliance as shown in section. Operation The front of the Roller Grill is fitted with a switch and a power regulator for each heating zone.
For Roller Grills with two heating zones, the control buttons on the right side control the front zone. Repairs and spare parts Repairs should only be carried out by authorised service personnel with knowledge of electrical equipment. Specifications for spare parts GL R22...
Page 13
Pos. Product no. Pcs. Description 15-10022 Cabinet GL10R22 complete 83-08950 Glide bearing 81-06085 Grease filter, O-ring 81-06067 Grease filter, V-ring 83-08869 Stainless drive roller 83-08805 Steel/Teflon drive roller 83-08854 Power regulator 83-08855 Rotary knob for power regulator 83-07505 Single pole switch, red 83-07507 Indicator light, yellow 83-08806...
Page 14
GL R28 Contains special parts for GL45/65 black model Pos. Product no. Pcs. Description 74--00005 Rotary knob Ø45/6MM 83-07505 Single pole switch, red 83-07507 Indicator light, yellow 83-08854 Power regulator 83-00111 Zone scale power regulator rear 83-00110 Zone scale power regulator front 83-10781 Grease tray GL16/28 82-06506...
4 Cleaning General Remember to use personal safety equipment. see 2.1 Before using the appliance for the first time, wipe all surfaces that will be in contact with food with a damp cloth. Do not use cleaning products that contain acid. Daily cleaning It is important to clean the Roller Grill daily after leaving to cool to <50°C.
5 Disposal Packaging The packaging should not be left in the environment, but should be disposed of in accordance with local regulations. When the appliance is no longer required The Roller Grill is labelled with a recycling symbol in accordance with Danish Executive Order 148 of 8 Feb- ruary 2018 (Electronic Waste Executive Order/Danish-Elektronikaffaldsbekendtgørelsen).