Lubrication And Adhesives - Epson STYLUS PRO XL 4004677 Service Manual

Stylus Pro Service Manual

6.3 LUBRICATION AND ADHESIVES

The printer must be lubricated properly when it is disassembled for component replacement, or if mechanical
noise exceeds a certain level. EPSON recommends only the lubricants listed in the table below for this
printer, both of which have been tested extensively and comply with the requirements of this printer
mechanism. Figure 6-1 shows the lubrication and adhesive points.
Type
Oil
Grease
Adhesive
Note: E = EPSON Exclusive product (Not commercially available)
Table 6-2. Lubrication and Adhesive Points
Ref. No.
1 The teeth of gear 60
2 The teeth of combination gear 10, 50
3 End point of shaft securing sub frame assembly
4 Cutout for the CR motor in the base frame assembly (2 points)
5 Shaft located in the center frame assembly
6 Shaft located in the center frame assembly
7 Surface of the eject roller assembly
Contact surface of the right side of the front paper guide and the
8
eject roller assembly
Right end point of the eject roller assembly
9
Contact surfaces of the shaft and combination gear 13.5, 22 and
10
the combination gear holder on the sub frame assembly
11 The teeth of gear 22.5
12 The teeth of combination gear 28, 17.5
14 End points of the pump speed-up shaft (both sides)
16 Cut point for knob on the right main frame
Contact points of gear 60, the platen roller shaft, and the PF cap
17
spring.
18 2 points on the combination gear holder.
19 Oil pad on the carriage
20 Contact surface of gear 25 and the plain washer
21 Contact surface of the platen shaft bushing and plain washer
22 Cutout in the platen roller shaft
27 Contact point of the pressure spring and washer
28 Combination gear 13.5, 22
30 The teeth of gear 24
(1) Angular spacer for the black head and the cartridge base
(2) Angular spacers for the color head and the cartridge base
The screw and washer attaching the ink cartridge holder to the
(3)
carriage base.
Rev.A
Table 6-1. Recommended Lubricants
Name
O-5
G-20
G-36
Neji Lock #2 (G)
Lubrication/Adhesive Point
Quantity Part No.
40 cc 1010513
40 gm B700000001
40 gm B703600001
1000 g B730200200
Maintenance
Availability
E
E
E
E
Lubricant
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-20 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
O5 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-20 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
G-36 (1-3 mg)
Neji Lock #2
(1-3 mg)
Neji Lock #2
(1-3 mg)
Neji Lock #2
(1-3 mg)
6-3