Mechanic; Electrician; Safety Regulations And Standards - AESYS Minerva Series User And Maintenance Manual

2 . 2 . 2 M e c h a n i c
2 . 2 . 2 M e c h a n i c
Definition: a person in charge of doing mechanical maintenance, adjustments, replacements and
repairs:

A skilled mechanic, able to service the mechanical assemblies safely and satisfactorily, due to
his theoretical knowledge and practical experience;

He is not authorized to work on electrical equipment of the VMS.
2 . 2 . 3 E l e c t r i c i a n
2 . 2 . 3 E l e c t r i c i a n
Definition: a person in charge of doing electrical/electronic maintenance, adjustments, replacements
and repairs:

A skilled electrician/electronic technician, able to service the electrical and electronic systems
safely and satisfactorily, due to his theoretical knowledge and practical experience;

He is not authorized to work on mechanical equipment of the VMS.
2 . 3 S a f e t y R e g u l a
2 . 3 S a f e t y R e g u l
Fully observance of the safety standards, not only enables the operator to work effectively and confidently,
but also without any risk of injury to him or to others. In addition:

make sure to shut off power (through the appropriate circuit breakers) when doing maintenance,
replacements or repairs of electrical equipment;

Make sure that the panel is installed on an adequate support that is suited to the operating
conditions and any existing risks (tampering, vibration, etc.), and verified by structural calculations
complying with the regulations in force;

Provide adequate lighting when working on the panel.
Caution: when working on the panel, do not remove its guards or safety equipment.
During normal use, the following instructions must be observed:

Always follow the procedures given for maintenance and technical assistance;

Keep a record of the dates and results of periodic inspections of the display;

Never use petrol, solvents or other flammable fluids to clean the display;

Use protective eye glasses with side guards in case of using compressed air (whether supplied in a
canister or compressor) for cleaning, and limit the pressure strictly to the necessary value;

Do not use open flames as a means of illumination;

Make sure that all live parts of the electric circuits are intact and in good working condition.
Aesys S.p.A. Via Pastrengo 7c - 24068 Seriate - BG - Italy • T. +39 035 29240 • F. +39 035 680030 • www.aesys.com -
t i o n s a n d S t a n d a r
a t i o n s a n d S t a n d a r
User and Maintenance Manual [ENG] - rel.00 (26/03/2018)
d s
d s
Registered office
Display Series Minerva Monochromatic
: Via Artigiani 41 - 24060 Brusaporto - BG – Italy
Pag.9 di 45