Partial Or Incorrect Display Of Message - AESYS Minerva Series User And Maintenance Manual

After activating a VMS, if no message is being displayed at the LED matrix, then after reading the
para 7.3Errore. L'origine riferimento non è stata trovata. "Replacing components" proceed as follows;
7 . 4 . 3 P a r t i a l o r i n c o r
7 . 4 . 3 P a r t i a l o r i n c o r
If the VMS is working, but the messages are being displayed only in parts or incorrectly; then proceed as
follows:
Aesys S.p.A. Via Pastrengo 7c - 24068 Seriate - BG - Italy • T. +39 035 29240 • F. +39 035 680030 • www.aesys.com -
No message displayed
Is the power
voltage correct?
message valid?
Are the FLAT cables
in good conditions?
Is the CPU card
working correctly?
Replace the faulty CPU
board 1216
r e c t d i s p l a y o f m e s s a g
r e c t d i s p l a y o f m e s s a g
User and Maintenance Manual [ENG] - rel.00 (26/03/2018)
Is the sent
e
e
Registered office
Display Series Minerva Monochromatic
Measure the correct
power voltage with
a multimeter
Check if the message
has been sent
correctly
Replace the damaged
cables
Check the correct
operation of the CPU
by means of the Aesys
LED software
: Via Artigiani 41 - 24060 Brusaporto - BG – Italy
Pag.40 di 45