Table of Contents
Advertisement
Changing The Dip Switch
DIP switches can be changed to match the headunit and rear camera being used
with this installation kit. Make these changes before installing the kit. Check the
rear camera and steering wheel control requirements for your devices.
Step1. Access the DIP switches via the cutout on the back of the Infoadapter
Step2. Using a pick tool, flick the switches to the required setting
Dip Switch Settings
Up = On, Down = Off
1: Pioneer & Sony code change. Dip 1 is ON for Pioneer models, Dip 1 is OFF for
Sony models. Check your headunits menu first to make sure the steering wheel
controls are activated. Refer to page 2-31 of this manual for more
information. Default is ON for most other models.
2: Setting for reverse camera. ON = PAL, OFF = NTSC.
The default setting is OFF (NTSC).
3: Resets the display settings back to default. If the display settings have been
manipulated in a way that it is no longer possible to make adjustments, change
the DIP switch #3 from OFF to ON and back. This will reset the screen settings
to the factory defaults. During this procedure the screen background will change
to red. While the background is red, no settings can be made.
4: Not applicable
2-14
Advertisement
Table of Contents
