Clearance Requirements - Electrolux 134700400 Installation Instructions Manual

Clearance requirements

IMPORTANT
DO NOT INSTALL YOUR WASHER:
1. In an area exposed to dripping water or out-
side weather conditions. The ambient temper-
ature should never be below 60° F (15.6° C) to
maximize detergent effectiveness.
2. In an area (garage or garage-type building)
where gasoline or other flammables (including
automobiles) are kept or stored.
3. On carpet. Floor MUST be solid with a maxi-
mum slope of 1 inch (2.54 cm). To minimize
vibration or movement, reinforcement of the
floor may be necessary.
INSTALLATION IN A RECESS OR CLOSET
If washer and dryer are installed in the same
closet, door ventilation is required: A minimum of
120 square inches (774.2 cm²) of opening, equally
divided at the top and bottom of the door, is
required. Louvered openings should be located 3
inches (7.6 cm) from bottom and top of door. Air
openings are required to be unobstructed when a
door is installed. A louvered door with equivalent
air openings for the full length of the door is
acceptable.
(7.6cm)
closet door
Installation Requirements
3"
(7.6cm)
60 sq. in.
(387.1cm²)
60 sq. in.
(387.1cm²)
3"
MINIMUM INSTALLATION CLEARANCES - Inches (cm)
SIDES REAR
Alcove 0" (0 cm) 0" (0 cm)*
Under-
0" (0 cm) 0" (0 cm)*
Counter
Closet 0" (0 cm) 0" (0 cm)*
0"
(0cm)
1"
(2.54cm)
TOP FRONT
0" (0 cm) n/a
0" (0 cm) n/a
0" (0 cm) 1" (2.54 cm)
0"
(0cm)
0"
(0cm)
5