Table of Contents
Advertisement
Connecting drain and electrical
1.
Snap one end of the drain hose hanger
(shipped in washer drum) onto the drain hose.
Continue wrapping it around the hanger and
snap it in place.
2.
Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable tie
(provided in the enclosure package) to the stand-
pipe, inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the water.
IMPORTANT
Check to ensure the power is off at a circuit
breaker/fuse box before plugging the power cord
into an outlet.
3.
Plug the power cord into a grounded outlet.
Grounding type
wall receptacle
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
Power cord with
3-prong grounded plug
4.
Turn on the power at a circuit breaker/fuse box.
5.
Carefully slide the washer to its final position.
Recheck for level and rock corners for stability.
Remove and discard door tape.
6.
Read the
Use & Care Guide provided with the
washer. It contains valuable and helpful infor-
mation that will save you time and money.
7.
See the next page about performing a brief,
helpful "Installation Cycle" on your new washer.
8.
If you have any questions during initial opera-
tion, please review the "Service Prevention
Checklist" in your Use & Care Guide before
calling for service.
9.
Place these instructions in a location near the
washer for future reference.
NOTE
A wiring diagram and technical data sheet are
located under the washer top panel, on top of the
detergent dispenser housing.
Installation Instructions
CABLE TIE
11
Hide quick links:
Advertisement
Table of Contents
