Connecting To Video Equipment (Video, S-Video, Component And Rgb Scart) - Eiki LC-XGC500 Owner's Manual

Connecting to Video Equipment (Video, S-video, Component and RGB Scart)

Cables used for connection
• Video Cable (RCA x 1)
• S-VIDEO Cable
• DVI-Digital Cable
(Cables are not supplied with the projector.)
Composite
S-video
Video
Output
Output
S-video DVI-Digital
RCA
cable
cable
cable
S-VIDEO VIDEO
✔Notes:
• The S-VIDEO jack connection overrides the VIDEO jack
connection when selecting AUTO in the Input Menu (p.35).
• When the Standby mode is set to "Eco" in the Setting,
MONITOR OUT and AUDIO OUT are disabled. (p.54)
• See page 79 for ordering optional cables.
Unplug the power cords of both the projector and external
equipment from the AC outlet before connecting cables.
• VGA-Scart Cable
• BNC Cable
Digital Output
(HDCP RGB Scart
compatible) 21-pin Output
VGA-
Scart
cable
ANALOG
DIGITAL
IN
(DVI-D)
Component Video
Composite
Video
Refer to the
(Y Pb/Cb Pr/Cr)
Output
Monitor Out
Signal Table
(next page).
BNC
VGA-
BNC
cable
Scart
cable
cable
MONITOR
Y Pb/Cb Pr/Cr
VIDEO
OUT
Installation
Output
21