Wieland podis MOT FP C Operation Manual page 11

2 | podis MOT FP C/CM/CP IIO/RS485 SEW Device Description
®
 podis MOT FP C/CM/CP IIO/ RS485 SEW Device
®
Description
. Variant overview
podis MOT FP C 2I2IO
83.252.xxyy.2
revos connector interface
for connecting the field
devicesPreassembled hybrid
cable to the consumer
(drive)
. General
The field distributors podis MOT FP C 2I2IO/RS485 SEW, podis MOT FP CM 2I2IO/RS485 SEW
and podis MOT FP CP 2I2IO/RS485 SEW are PROFIBUS-DP actuator/sensor module on the
podis energy bus for the control and energy supply of SEW MOVIMOT AC motors with inte-
grated frequency inverter and serial communication (RS485)
The communication between field distributor and MOVIMOT is carried out via a galvanically
isolated RS485 interface. MOVILINK profile from SEW is the protocol being used.
The PROFIBUS controller controls the complete data exchange with the PROFIBUS master.
The isolated RS485 interface serves as transfer medium.
The connection between field distributor and drive is implemented using a prefabricated
hybrid cable and plug connector.
Using prefabricated M12 connecting lines allows for connecting 2-wire and 3-wire sensors
to the four free inputs. The sensors are supplied from the field distributor via the PROFIBUS
interface.
Addressing the field distributor is carried out via the settings of two rotary switches. The
digital inputs are read via the M12 sockets without being processed by the operating system
and transferred to the PROFIBUS master upon request.
To display the current switching state and the status of the inputs, each channel features an
LED in the housing cover of the field distributor.
The contact to the energy bus is established via penetrating screws.
Wieland Electric | BA000349 | 05.2007
podis MOT FP CM 2I2IO
83.252.xxyy.4
same as 83.252.xxyy.2, but
with repair switch
podis MOT FP CP 2I2IO
83.252.0005.2
revosMOT connector inter-
face directly atpodis field
®
distributor
.