Exhaust Hose Installation - EdgeStar AP310SS Owner's Manual

1) Exhaust Hose Installation

The exhaust hose must be installed onto the unit before any further installation can
occur.
a) Pull out about 6" of one end of the exhaust hose.
b) Screw the exhaust connector onto the exhaust hose in a clockwise motion.
c) Snap the exhaust connector into place in the back of the unit.
See below for a few notes about exhaust hose installation:
Note:
Mounting the exhaust hose
The suppl i ed exhaust hose can be
ext ended f r om 16 i nches t o 63
i nches l ong f or m ount i ng. For best
oper at i on, use t he shor t est ,
st r ai ght est possi bl e conf i gur at i on.
Avoi d ki nks i n t he hose, w hi ch m ay
dr ast i cal l y r educe t he cool i ng
pow er of t hi s uni t .
Warning!
The l engt h of t he exhaust hose
suppl i ed w i t h t hi s uni t i s
speci al l y desi gned f or i t . D o not
ext end i t l est t he uni t
m al f unct i on.
8