Gas Regulations; Connecting To Lpg - AEG C41022G User Instructions

Instructions for the installer

12.7 Gas regulations

If the cooking appliance is set up for a different type of gas than that available, its injectors must
be replaced, the minimum flow regulated. In order to replace the injectors in the cooking hob, it is
necessary to carry out the following operations:
• remove the pan supports;
•
remove the burners and burner caps (Fig. A);
• take out the injector (Fig. B) and replace it with one
suitable for the new type of gas (see "G
");
INJECTORS TABLE
• replace the gas label (on the rear of the appliance) with
the new one provided with the injectors kit;
•
refit all parts by following the disassembly instructions in
reverse order and taking care to position the burner cap
correctly on the burner.
12.7.1 Minimum flow of valved cooking hob taps
• Switch on the burner and turn the control knob
towards the minimum flow position ;
•
remove the knob;
•
using a screwdriver, adjust the internal screw Z
until the correct low flame is obtained;
•
refit the knob.
12.7.2 Minimum flow of non-valved cooking hob taps
•
Switch on the burner and turn the control knob
towards the minimum flow position ;
•
remove the knob;
•
insert a small screwdriver into the rod of the tap
and adjust the internal screw Z until the correct
low flame is obtained;
• refit the knob.
• Unscrew the adjustment screw Z to increase the flow, or tighten it to reduce the flow.
• The adjustment is correct when the low flame measures approximately 3 or 4 mm.
• When changing quickly from maximum to minimum flow and vice versa make sure that the
flame does not go out.
TYPE OF GAS mBar
NATURAL GAS 20
LPG 30
BUTANE 28
PROPANE 37

12.8 Connecting to LPG

Use a pressure regulator and connect to the cylinder in compliance with the guidelines set out in
standards regulations in force.
Note: L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any
boat, yacht or other vessel.
GENERAL INJECTORS TABLE
BURNERS
NOZZLE NO.
POSITION TYPE
115 RAPID
97 SEMI RAPID
72 AUXILIARY
128 TRIPLE-RING
94 FISH KETTLE
85 RAPID
65 SEMI RAPID
50 AUXILIARY
93 TRIPLE-RING
68 FISH KETTLE
ENERAL
POWER Watt
MAX. MIN.
3000 750
1750 480
1000 330
3300 1300
1900 750
3000 750
1750 480
1000 330
3300 1300
1900 750
CONSUMPTION
MAX.
286 l/h
167 l/h
95 l/h
314 l/h
181 l/h
219 g/h
128 g/h
73 g/h
241 g/h
138 g/h