Change Ip Address - Rational iVario Original Installation Manual

en
Pre-requisites
a
The electrical compartment is open.
a
The unit is switched on.
a
The settings for
adapter have been made.
1. Connect the Ethernet cable of the WiFi
adapter to a computer.
2. Note that the WiFi on the computer is
disabled during the configuration.
Logging in
1. Open a web browser and enter the ad-
dress https://192.168.11.1 or another
previously set IP address. Accept the
necessary certificates.
2. Enter the username and password. By
default the username is root and the
password is Rational [
>
Press the Login display text.
Configuration
1. In the Network / WiFi menu, press the
Add [ Photo
2. Enter the name for the expanded WiFi
in the ESSID field [
>
Access point must be set as Mode.
3. Select WiFi encryption tab. Select the
display text to the right of the pass-
word field to make the default pass-
word visible [
note of the password in a safe place.
Confirm the entries with the Save dis-
play text.
>
A new network appears in the WiFi
overview [
4. Confirm with the Save & Apply display
text.
18 / 120
} Use as a WiFi client
Photo 15].
19] display text.
Photo 20].
Photo 21]. Take a
Photo 22].
80.51.915_iVario-iVarioPro-VCC_WiFi-Adapter_IM_EU-west
5. Test the connection. Unplug the Ether-
net cable and connect the laptop to the
new WiFi. Enter the SSID and the
password noted down in the previous
step in full.
>
A website can be opened.
6. Connect the Ethernet cable in the unit.
7. Close the electrical compartment.
>>
The WiFi created can be used by other
WiFi adapters and units in WiFi client
mode. To do this, the configuration
must be carried out with the SSID cre-
ated and the password noted down.

4.2.3 Change IP address

NOTICE
Connection test fails despite sufficient
signal strength
If the WiFi adapter has the same IP
address as the access point, the
connection test will fail, despite good
signal strength and correct
configuration settings for the WiFi
network.
Resolve the IP address conflict:
Check the IP address set on the
n
access point.
Change the IP address set on the
n
WiFi adapter.
1. Log into the menu.
2. Set a different IP address in the main
menu under Menu - System - LAN IP
address .
3. Follow the instructions on the screen.
>
Use the newly set IP address to ac-
cess the web interface of the WiFi
adapter.
>>
Repeat the connection test.
4 | Installation