Names And Functions Of Parts - YOKOGAWA FB200 User Manual

1.3

Names and Functions of Parts

Holes for M3 attachment screws (6 locations)
1-4
The figure below shows the outline and the arrangement of parts such as the optical
input, interface connector, and mode switch.
• Mode Switch
The mode switch is located inside the side panel cover. You can set the operation
mode, transfer rate, and other parameters by using these switches.
• Interface Connector
The interface connector consists of the communication interface and power supply
interface. The communication interface is the RS-422.
• Optical Input
The fiber light is applied here. The optical connector is of an FC type (standard), and
the fiber supports the SMF (Single Mode Fiber).
• Holes for Attachment Screws
These holes are used to attach the FB200C/FB200L in the system.
Mode switch
8 7 6 5 4 3 2 1
ON
Mode switch Optical input
Interface connector
IM 703753-01E